User’s Guide ____________________________________________ Schooners II Wireless 900MHz Speaker System Schooners II 900MHz Wireless Speaker System Model: GDI-AQSHR200 /AQSHR21
IMPORTANT: Please read your User’s Guide before using your system INTRODUCTION Your SCHOONERS II speaker is designed using the latest wireless technology to enjoy audio anywhere inside or outside your home. Simply connect the desired audio source (Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD player) to the speaker transmitter. IMPORTANT SAFETY INSTRUCTIONS 1. Read & keep these instructions. 2. Keep these instructions. 3. Follow all warnings and cautions 4. Do not use this apparatus near water. 5.
FEATURES 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Automatic PLL (Phases Lock Loop) scanning system on speaker receivers. PLL (Phase Lock Loop) transmitter transmission system.
SET UP TRANSMITTER 1. Connect the AC power adaptor included with your unit to electrical wall outlet. 2. Plug the AC power adaptor included with your unit in the jack located on the rear of the transmitter. Option 4 X “AA” size ALKALINE batteries can be used to power the transmitter for portability. NOTE: ensure battery polarity (+/-) are matched and correctly aligned correct when inserting the batteries in the compartment 3.
SPEAKER (RECEIVER) 1. Connect the 12V power adaptor to the DC input jack on the bottom of each speaker, then plug into the power wall outlet. You may also insert 6 x ‘AA’ size ALKALINE batteries into the battery compartment. Ensure the batteries polarity (+/-) are correct, at the bottom of the speakers (batteries not included in the package). 2. Press the POWER button and turn the speakers ON. The POWER LED will light up in blue.
Î Keep a distance of the speaker up to 7 meters apart from transmitter, and then press “SCAN” auto-tuning button for best tuning reception. Î Should you experience a “frequency jam”, adjust the channels by switch from one channel to the other channel on the transmitter, and then press the “SCAN” AUTO TUNE button on the speaker again. NOTE: The signal from the transmitter will decrease in strength over increased distances and as barriers and interference increase. 5.
NOTE: IF disruption should occur (signal breaks up), press the “SCAN” auto-tuning button on the speaker to maximize best reception. If you hear interference from other components, switch between the channels on the transmitter and press the “SCAN” auto-tuning button for best reception. NOTE: batteries should be removed from the transmitter & speaker in cases of extended storage periods. Move the speakers indoors when weather conditions are extreme. 6.
SPECIFICATIONS Transmission Mode : UHF stereo Carrier Frequency : 900 MHz Operation Voltage : Transmitter, 4 X ‘AA’ sixe Alkaline batteries (not included) or DC 12V 200mA Speaker, 6 X ‘AA’ size Alkaline batteries (not included) or DC 12V 1.2A adaptor Frequency Response : 40Hz – 12KHz Distortion : 1.
P.
