Owner`s manual

9
SETTING THE OUTPUT CONTROL
The OUTPUT control provides 20dB of variable level control at the output of the m102. After setting
your desired input and threshold levels, you can set the over all output of the m102 with this control.
Use the OUTPUT to properly match to the input of your converter, interface or whatever is next in your
signal path. Also, your signal level may have been be reduced by heavy compression settings, so the
OUTPUT control can also be used to provide makeup gain.
PEAK LED
The PEAK LED is used to monitor any peaks within the m102. It turns green at -15dBu and red at
+20dBu. The m102’s internal headroom is +26dBu, so occasional red is ne, just a warning that you are
6dB away from clipping. If the light is mostly red, then you are probably clipping the unit all your gear
downstream.