Owner`s manual

6. SIDECHAIN / LINK / NORMAL - This switch is to activate either a) linking of two m102’s for use in stereo

compression scenarios, or b) to activate external side chain control of the compressor for ducking, de-essing

etc, or c) for normal compressor operation.

7. OUTPUT - The output control provides 20dB of variable level control at the output of the m102, from -10dB

to +10dB. This control is useful for small level adjustments during tracking or for compression gain makeup.

8. POWER / OUT / IN SWITCH - This 3 position switch activates the power supply circuitry and engages the

compressor circuitry.

9. PEAK INDICATOR - The LED peak indicator, which monitors the signal at the output of the compressor,

illuminates green at -10dBu and red at +20dBu (6dB before clipping).

10. GR METER - This 10 segment meter displays the amount of gain reduction being applied to a signal in the

compression circuit.

Rearpanel Connections

PUSH

INPUTOUTPUT

STEREO LINK /

SIDECHAIN INPUT

GRACE DESIGN BOULDER, CO USA

100-240V

50-60Hz 7W max

RoHS

COMPLIANT

1. LINE INPUT - Balanced line inputs, XLR wired pin 2 positive, pin 3 negative and pin 1 ground, TRS wired tip

positive, ring negative, and sleeve ground.

2. LINE OUT - Balanced line outputs, XLR wired pin 2 positive, pin 3 negative and pin 1 ground, TRS wired tip

positive, ring negative, and sleeve ground.

3. STEREO LINK/ SIDECHAIN - This 1/4” input accepts either the connection from another m102 for linking

compressor controls for stereo use, or an external side chain signal source to control the compressor for

ducking or de-essing applications. In sidechain mode, the connection is unbalanced with only the tip

connected, so simply use an unbalanced 1/4” connector. Link mode requires a TRS 1/4” inch cable.

4. POWER SUPPLY - A universal input AC supply provides mains power to the m102. A standard three

prong AC power cable is included with the m102. For safety, the power supply cord must be

connected to a grounded outlet. The Disconnect Device for the m102 is the Mains plug or the

Appliance Coupler on the power supply cord. The Disconnect Device must remain accessible and operable.