Owner's Manual

12
10.4 INTERNAL JUMPER LOCATIONS
J7 congures the HIGH
EQ corner frequency. It is
set to HF1 at the factory
(2kHz corner frequency).
J6 congures 12V power,
which can be applied
to tip, ring, or set to o.
Set these according to
how your microphone /
instrument is wired. Set
to OFF at the factory.
J21 congures the LOW
EQ corner frequency. It is
set to LF1 at the factory
(125Hz corner frequency).
J13 sets the pad settings
for the insert send. Levels
are -6dB, -16dB, or o. Set
to OFF at the factory.
J2 activates the boost
knob for gain trim mode,
providing an additional
variable 10dB of gain
when Footswitch 2 is
in set to INSERT. Set to
BOOST at the factory.
J10 congures FX insert
return mute. When ON,
reverb and delay tails
are cut o when FS2 is
activated. Set to OFF at
the factory.
J4 selects between high
low gain settings for the
1/4" instrument input. Set
to LOW at the factory.
LF 125Hz
LF 250Hz
J21
HF 2kHz
HF 1kHz
J7
GAIN TRIM
BOOST
BOOST KNOB
J2
OFF
-6dB
INSERT PAD
-16dB
LF SHELF
HF SHELF
ON
OFF
OFF
TIP
INST 12V
POWER
INSERT RETURN MUTE
RING
J10
J6
J4
HIGH
LOW
INST GAIN