User Manual

For the most up-to-date version of this
User’s Guide, go to www.gpx.com
PC101B
Portable Compact CD Player
USER’S GUIDE
V: 983-01
Introduction
CD DOOR
PLAY/PAUSE
Press to play or pause
a loaded CD.
STOP/OFF
Press to stop a CD
during play. In stop
mode, press to power
o the CD player.
MODE
Press to repeat a
single track or an
entire CD, play tracks
in a random order, or
play the CD in intro
mode.
OPEN
Press to open the CD
DOOR.
SKIP/SEARCH
Press to skip between
tracks on a loaded
CD. Press and hold to
search an individual
track on a loaded CD.
PROG
Press to program a
loaded CD to play
tracks in a specied
order.
VOLUME
Press to adjust the
volume.
DC POWER INPUT
STEREO
HEADPHONE JACK
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
• WARNING: To reduce the risk of re or electric shock, do not
expose this apparatus to rain or moisture.
• AVERTISSEMENT: Pour réduire le risque d’incendie ou de
choc électrique, ne pas exposer cet appareil sous la pluie et
l’humidité.
• CAUTION: Use of controls or adjustments or performance of
procedures other than those specied may result in hazardous
radiation exposure.
• WARNING: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture
surfaces with any type of soft, porous, or sensitive nish. As
with any rubber compound made with oils, the feet could cause
marks or staining where the feet reside. We recommend using a
protective barrier such as a cloth or a piece of glass between the
unit and the surface to reduce the risk of damage and/or staining.
• WARNING: Use of this unit near uorescent lighting may
cause interference regarding use of the remote. If the unit is
displaying erratic behavior move away from any uorescent
lighting, as it may be the cause.
• CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
• PRÉCAUTION: Danger d’explosion si les piles sont
remplacées de façon incorrect. Remplacer les piles seulement
par le même type de pile ou l’équivalent.
• WARNING: There is a danger of explosion if you attempt
to charge standard Alkaline batteries in the unit. Only use
rechargeable NiMH batteries.
• WARNING: This product may contain chemicals known to the State of
California to cause birth defects, or other reproductive harm (California Prop
65). Wash hands after handling.
• This product meets and complies with all Federal regulations.
Main plug is used as disconnect device and it should remain
readily operable during intended use.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
Batteries should be recycled or disposed of as per state
and local guidelines.
Ne pas mélanger vieilles et nouvelles batteries.
Ne mélangez pas des piles alcalines, standard (carbone-zinc) ou
rechargeables (Ni-Cd, Ni-MH, etc) batteries.
Piles doivent être recyclées ou éliminées selon les directives
étatiques et locales.
Warnings and
Precautions
FCC Warnings
WARNING: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.