Product Manual

5252 East 36th Street North
Wichita, KS USA 67220-3205
TEL: [phone]
FAX: [phone]
INSTALLATION
HP-90
Petroleum Hand Pump

Know and follow applicable national, state and local
safety codes pertaining to installing and operating equip-
ment for use with petroleum uids
Make sure the tank is vented to prevent the buildup of
pressure and possible fuel leakage through the nozzle.
Use the following procedures to install the HP-90 Hand
Pump on a tank with a 2-inch NPT bung.

1. Place PVC pipe into ared end of PVC pipe assem-
bly. Use PVC cement if desired. The end of the pipe
should be 2-3 inches above the bottom of the tank,
when installed correctly. Cut pipe to t tank.
2. Remove the two protective plugs from the inlet and
outlet ports.
3. Wrap the threaded end of the suction pipe with 3 to
4 turns of thread tape.
4. Install the suction pipe into the pump inlet and tighten
with a wrench.


1. Lubricate the male threads on the pump inlet with
thread tape or a thread-sealing compound approved
for use with petroleum fuels.
2. Thread the pump onto the tank and turn pump to
tighten securely.


1. Slide the grip onto the pump handle.
2. Install one end of the link in the pump housing, the
other end in the bottom hole in the pump handle.
Connect the pump handle to the shaft with the clevis
pin and secure with the cotter pin.
Lubricate all Pin Joints with grease
to extend the life of your hand pump.
Rev. - 921925-0609/11