User's Manual

- Change the IP address (camera)
- Configuring the camera
4. Camera Operating Procedures
LED Operation
LED 1
- Recording : Flashing Red (1 second intervals)
- Mute : Flashing Red (300ms intervals)
LED 2
- Standby : Solid Green
- Charging : Solid Red
- Charge Complete : Solid Green (No LED indication while charging if the power is off)
Basic Operation
When LED, vibration and beep modes are enabled. (Default mode)
Record: Press the Record & Stop button once to start recording (1 short beep + 1 short vibration + LED1 flashing
Red with 1 second intervals)
Stop: Press and hold the Record & Stop button for more than 2 second to stop recording (2 short beeps + LED2
solid Green+ Vibration)
Audio Mute: Press and hold the Mode button for more than 2 seconds (LED1: Flashing Red with 300ms intervals)
NOTE: Enable only during operation. Mute will disable automatically at the end of the recording.
Status Check
LED 1
LED 2