Information

Product Specification Model No.: GP210AAHCE
Document Number: MQS7508 Revision: 00 Page 4 of 5
Manufacturer reserves the right to alter or amend the design, model and specification without prior notice.
4. RECYCLED MATERIAL CONTENT
Rechargeable Nickel Metal Hydride Battery Made with Minimum 10% Recycled Materials
5. CONFIGURATION, DIMENSIONS AND MARKINGS
Please refer to the attached data sheet.
6. EXTERNAL APPEARANCE
The cell / battery shall be free from cracks, scars, breakage, rust, discoloration, leakage and deformation.
7. WARRANTY
One year limited warranty against workmanship and material defects.
8. CAUTION
1. Batteries should be charged prior to use.
2. For charging methods please referred to our technical handbook.
3. Use the correct charger for Ni-MH batteries.
4. Do not reverse charge batteries.
5. Do not subject batteries to adverse condition such as extreme temperature, deep cycling and
excessive over charge/over discharge.
6. Avoid batteries being used in an airtight compartment. Ventilation should be provided inside the
battery compartment; otherwise batteries may generate hydrogen gas, which could cause an
explosion if exposed to an ignition source.
7. Do not attempt to take batteries apart or subject them to pressure or impact, Heat may be generated
or fire may result. The alkaline electrolyte is harmful to eyes and skin, and it may damage clothing
upon contact.
8. Keep away from children, if swallowed, contact a physician at once.
9. Do not short circuit batteries, permanent damage to batteries may result.
10. Do not incinerate or mutilate batteries, may burst or release toxic material
11. Do not solder directly to cells or batteries.
12. Store batteries in a cool dry place.
13. If find any noise, excessive temperature or leakage from a battery, please stop its use.
14. When not using a battery, disconnect it from the device.
15. When using a new battery for the first time or after long term storage, please fully charge the battery
before use.
16. Do not mix new batteries in use with semi-used batteries, over-discharge may occur.
17. When connecting a battery pack to a charger, ensure correct polarity.
18. When the battery is hot, please do not touch it and handle it, until it has cooled down.
19. Do not remove the outer sleeve from a battery pack nor cut into its housing.
20. When find battery power down during use, please switch off the device to avoid over discharge.