Instructions / Assembly
Table Of Contents
- 1 Introduction and Safety
- 2 Handling and Storage
- 3 Technical Description
- 4 Installation
- 5 Use and Operation
- 5.1 Precautions
- 5.2 Before starting
- 5.3 First starting
- 5.4 Air purge
- 5.5 Setting the timer
- 5.6 Operation modes
- 5.6.1 Fix speed models
- 5.6.2 Variable speed models
- 5.6.3 Fix speed models with fix value temperature control
- 5.6.4 Fix speed models with variable value temperature control
- 5.6.5 Autocirc pumps
- 5.6.6 LED light
- 5.6.7 Motor protection from overtemperature
- 5.6.8 Dry run protection
- 5.6.9 Power Down Reset (PDR)
- 5.6.10 Temperature sensor error mode
- 6 Maintenance
- 7 Troubleshooting
- 8 Technical Information
- 9 Disposal
- 10 Warranty
en – Original Instructions
26 Installation, Operation and Maintenance Manual
1. Loosen the screw ring before installation.
2. Rotate the pump motor to the required installation position.
3. Tighten the screw ring.
When installing the recirculating pump in a horizontal position, the timer shall point upwards. It
may be turned in the range from 10:30 to 13:30 (±45°) at maximum, in order to maintain the
ingress protection class (see
Figure 13 on page 26).
Rotating the pump motor (vertical installation)
Figure 12
Rotating the pump motor (horizontal installation)
Figure 13