Warranty

Model with fixed thermostat -
• A built-in temperature sensor automatically turns the pump ON when the
water temperature in the
hot water supply line cools down to 89.6°F (32"C) . The
pump then moves the cool water in the hot water supply line into the cold
water supply li ne .
•
Autocirc Pump turns OFF automatically when water temperature reaches 95 °F
(35°
C), ensuring instant availability of warm water with hot water only seconds
behind.
• When the pump is OFF, a built-in auto closure device (check valve)
prevents hot and cold water mixing.
• Hot water will also be instantly available at all other fixtures between the
water heater and the sink under which the Autocirc pump is installed.
The Autocirc
Pump System - Typical Schematic Diagram
Cold
Water
In let
Wa ter
He ater
No Recirculation Line Required
115 volt
outlet
Note: At the sink under which the Autocirc pump is installed some
"luke warm" water will appear in the cold water line due to the
transfer
of water from the hot side to cold side. This luke warm
water will, however, disappear in a short time (4-5 seconds) once the
cold fauceVtaps is opened.
Autocirc ® Technical Data
Motor : 115 Volt, 1 Phase, 60Hz
Unit Weight:
Overall Dimensions:
60 Watts
5.5
Ibs (2.35kg)
7" height (17 .8cm)
6" width (15.2cm)
Austra ia
This pump must be installed in accordance with AS3500.
U. L. Caution
This pump has been tested using water only. Its suitability for use with liquids other than
water is the end user's responsibility.
2