Quick Install Guide

ManualsBrandsGouldin Technologies ManualsWearable TechnologyWatchman

Quick Install Guide

2020

WXL-P Series

INSTALLER TEST CODE:

CODE WILL STOP WORKING AFTER 10 USES.

18 gauge stranded - up to 25 feet.

16 gauge stranded - up to 50 feet.

12 gauge stranded - up to 60 feet.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This transmitter must not be co-

located or operating in conjunction with any other antenna or transmitter.

This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

CellGate Support: 972-231-1999 option 3

Summary of content (6 pages)

PAGE 1
2020 WXL-P Series Quick Install Guide INSTALLER TEST CODE: 18 gauge stranded - up to 25 feet. 16 gauge stranded - up to 50 feet. 12 gauge stranded - up to 60 feet. CODE WILL STOP WORKING AFTER 10 USES. CellGate Support: 972-231-1999 option 3 FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 2
WXL **Recommended wiring: 18/6 shielded for main device, and 18/4 shielded for optional wiegand devices** Items Included in Kit ❶ Watchman XL Unit ❷ 12 Volt DC Power Supply ❸ Magnetic Read Switch ❹ Keys (Note: Leave one key with the customer) ❺ Nuts X 4 Watchman XL Unit Interface Circuit Board ❻ Bolts X 4 ❼ Quick Install Guide ❽ Activation & Test Process ❾ Customer Information Packet Power Supply Wiring Router Ethernet Switch - Interface Circuit Board (Oriented the same as the Watchman install) Impor
PAGE 3
WXL Interface Wiring Diagram (Oriented the same as the Watchman install) ❷ ❸ ❶ ❹ 6-Wire Installation Instructions ❶ Wire main power from the transformer to the power connector on the circuit board. ❷ Connect gate trigger wires from the Normally Open (NO) and Common (C) to the free-exit or exit terminals on the gate operator. ❸ Connect the gate status wires on the 6-pin connector on the main relay and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC) relay on the gate operator.
PAGE 4
WXL Installation Testing Enter the Testing Code, then tap the Enter Button. Call List Home Enter a Code Enter Button The Code will activate Relay 1 (the gate should open). Locate a Callgroup and tap on it to call it. Callgroup An automated message will play confirming the call was successful.
PAGE 5
WXL External Camera Installation. • If you’re installing an External Camera, call CellGate Support for testing. • CellGate Support: (972) 231-1999 option 3. Customer Information Leave the following items with the Customer: • Customer Information Packet • WXL - Key Installation Complete • Customer will setup Account with information in the Customer Packet.
PAGE 6
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.