Glide A SMARTER HOVERBOARD USER MANUAL
Congratulations on your purchase!
This user manual will help you operate your new hoverboard. Be sure to read ALL OF THE INFORMATION in this manual before riding. NOTE TO ALL RIDERS UNDER 18 YEARS OF AGE: important that you get parental permission before riding your hoverboard.
Don’t ride until you read this ALWAYS wear a helmet when riding your hoverboard. Make sure your hoverboard has a full battery before taking it out to ride. Always be aware of local road laws, and follow them. WARNING To reduce the risk of injury, adult supervision is required, never use in roadways, near cars, on or near steep inclines or steps, swimming pools or other bodies of water; always wear shoes, and never allow more than one rider at a minimum. Do not Always respect pedestrians.
Warning Message 1. Avoid water - The hoverboard is not waterproof. The electronics may be damaged due to water and water damage is not covered by our warranty. Riding in wet conditions is also very dangerous and may result in injury. 2. Abuse - We do not cover physical damage due to negligent care and extreme riding. 3. Whenever you ride the GOTRAX Hoverboard , you risk severe injury or even death from loss of control, collisions, and falls. Use caution and ride at your own risk. 4. Do not 5.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
1. SRX PRO Hoverboard 2. SRX PRO Approved Power Adapter / Charging Unit Unpack 1. Hoverboard 2. Approved Power Adapter / Charging Unit Remove all packaging material, then inspect each item for any accidental damage that may have occurred during shipping.
any ng. Get to know your hoverboard The hoverboard comes fully assembled. Top Speed: Distance per Charge:: Battery Type: Battery Charger: Charge Time: Motor Power: Power Requirements: FCC ID: 6.2mph 3.1 Miles 25.2V 2.6AH DC 29.4V 0.
1. Insert the charging plug into the port. 2. The charger box will have a green light when fully charged and a red light when charging. Charge your hoverboard Before using the hoverboard, you must fully charge the battery. 1. Insert the charging plug into the port. 2. The charger box will have a green light when fully charged and a red light when charging.
Hoverboard Functions To power the hoverboard on, press and hold the silver button on the back of your hoverboard for 1 second. your hoverboard for 1 second. press the silver button on the back of Mode Switch: 1. Double-click the switch button within 1.5 seconds in the shutdown state to switch between self-balancing and non-self-balancing modes. 2.
To Turn Left: Push gently down with your right toes. Be prepared to shift your weight to the left. Slow to Stop: balanced. Return to an upright position with your weight evenly Low Battery: When the hoverboard is low on battery and about to die, charge. Overheat Alarm: The motor will overheat after a long time of high speed running. When the motor temperature is high, it will keep beeping, and the all the time.
Riding Tips 1. You will want to start riding your by mounting the board from the rear. charging port. 2. Place your hoverboard on the ground directly in front of your feet. Step with one foot onto the platform, and then quickly step up onto the hoverboard with your second foot. 3. Always dismount from the back of the hoverboard. 4. The hoverboard performs best when on a smooth surface e.g. car parks, smooth roads, footpaths. and it needs to be maintained. 6.
Bluetooth Setup The hoverboard features a Bluetooth speaker that can be paired with any mobile device to play audio. The Bluetooth speaker is automatically enabled when the hoverboard is turned on and will remain enabled and discoverable as long as the hoverboard is powered on. Read the instructions below to learn how to operate the hoverboard Bluetooth speaker. 1. To turn on the Bluetooth speaker, power on the hoverboard as normal. 2.
Maintenance & Repair If you regularly clean and maintain your electric hoverboard, it will extend its life. Cleaning and storage: soft damp cloth. If the hoverboard is dirty, wipe it clean with a DO NOT use alcohol, gasoline, kerosene, or other corrosive chemical solvents to clean the hoverboard. It can severely damage the appearance and structure of the hoverboard. Please do not use a pressure washer as it may also cause damage to the electronics. Storage: location.
Troubleshooting: One of the most common solutions for hoverboard issues is calibrating your board. Here are the steps involved in 1. Start with the hoverboard powered off. 2. Adjust the foot pedals until they are level with each other and the ground. 4. Press the power button to turn off. 5. Press the power button to turn on. The hoverboard will be calibrated and ready for galactic adventures.
Battery Information Only use the approved GOTRAX power adapter to charge your Improper disposal of used batteries may seriously pollute the environment. Please comply with local disposal regulations. Make sure to store your hoverboard and power adapter in conditions that do not exceed 104 degrees Fahrenheit or below 32 degrees Fahrenheit.
Troubleshooting We frequently update our user manuals at GOTRAX .com , and reserve the rights to update and change manuals online. Please contact our customer service team if you are experiencing problems or need more detailed information. They can be reached at GOTRAX .com Warranty For warranty information, please visit GOTRAX .com .
W W W . G O T R A X .
GOLABS, INC GOTRAX .
