Operation Manual

GOSSEN Foto- und Lichtmesstechnik GmbH 13

Save found studiosets to memory if you will use them frequently (see section 3.3.3, “Saving
Studiosets”, on page 14).
Initialization can be avoided in this way when you switch your DIGISKY on. In this case, only
the units/modules in the stored sets are detected and initialized.
3.3.2 Adding Devices Manually
Elinchrom flash units which are not equipped with an RX module can be added
to the device list manually, and assigned to a group at the same time.
If you have devices both with and without RX modules, start auto scanning (see
section 3.3.1 on page 12) and add other available flash units to the device list
manually after auto scanning has been completed.
List of devices currently integrated into the DIGISKY:
 Style 100 FX / Style 400 FX / Style 100 BX / Style 400 BX
 Quadra AS
 BX 250 Ri / BX 500 Ri
 FX 200 Ri / FX 400 Ri / FX 600 Master
Assignment to a Group
Select Add Device Manually
with the ring controller and
continue to device
selection.
Select the desired device
with the ring controller.