Datasheet
GMC-I Messtechnik GmbH 9
PROFITESTINTRO
Tester, IEC 60364-6 / DIN VDE 0100-600
PRO-JUMPER
Touch-
guarded
short-circuit
adapter for
the
PROFITEST
INTRO for
measuring
cable com-
pensation
Z550A Test Probe for Remote Triggering
Test Probes (length: 68 mm, diameter: 2.3 mm)
Probe Set (Z503F)
PRO-PE Clip – Flat Test Clip for Busbars (Z503G)
TELEARM 120 Telescoping Rod
Floor Probe
The 1081 floor probe
makes it possible to mea-
sure the resistance of insu-
lating floors in accordance
with DIN VDE 0100-600,
and EN 1081.
Magnetic Measuring Probes (patented)
with Magnetic Strain Relief (Z502U)
3-Phase Current Adapter
A3-16, A3-32 and A3-63
3-phase adapters are used
for trouble-free connection
of test instruments to
5-pole CEE outlets. The
three variants differ with
regard to plug size, which
corresponds respectively
to 5-pole CEE outlets with
current ratings of 16, 32
and 63 A. Phase sequence
is indicated with lamps at
all three variants. Testing
the effectiveness of safety
measures is conducted via five 4 mm sockets with touch protec-
tion.
VARIO Plug Adapter Set
Three self-retaining test
probes with touch protec-
tion for the connection of
measurement cables with
4 mm banana plugs, or
with touch protected plugs
for sockets with an open-
ing of 3.5 mm to 12 mm,
e.g. CEE, Perilex sockets
etc. For example, the test
probes also fit the square PE jacks on Perilex sockets. Maximum
allowable operating voltage: 600 V per IEC 61010.
ISO Calibrator 1
Calibration adapter for rapid, effi-
cient testing of the accuracy of
measuring instruments for insula-
tion resistance and low-value
resistors
D CH GB
Z503J Z503P Z503R
Measurement Key
Key for Measuring
Measuring Point Illumination
Point Illumination
Safety Cap
Safety Collar
Test p rob e
Connection example: plug-in location at
PROFITEST INTRO
Moving touch protection reliably
covers the magnetic contact pin
by means of spring force.
Magnetic
Strain Relief