Operation Manual

18 GMC-I Messtechnik GmbH

Initial Start-Up – Setup

4.2 Battery Operation

Installing the Battery Pack

Attention!

If a DUT is connected to the test socket, disconnect it first.

Do not disconnect the test system from the mains while

changing the battery pack, if you want to prevent the loss of

current configuration data.

Opening the Battery Compartment Lid

Loosen the two captive slotted screws with the help of a coin.

Remove the battery compartment lid.

Connect and insert the battery pack (see figure).

1. Connect the battery pack by inserting its plug until the latch

snaps into place. (In order to disconnect the plug,

simultaneously press the latch towards the plug and pull the

plug out.)

2. Insert the battery pack. Make sure that neither the connector

cable nor any portion thereof is located underneath the battery

pack.

3. Stow the connector cable in the empty space to the right of

the inserted battery pack.

Closing the Battery Compartment Lid

Set the battery compartment lid back into place and retighten the

two screws.

If a fully charged battery pack has been installed and the test sys-

tem is not connected to the mains, the battery symbol ap-

pears at the display after start-up and login, and the number of

dark bars indicates the battery charge level. After installing the

battery pack, the device is automatically supplied with power from

the batteries.

See also energy options in section 4.10.8 on page 27.