Operation Manual

SECULIFE IF+
SCREENS
MAIN SCREENS – There are four main screens: Chamber 1, Chamber 2, DUAL and Connector. The
available screens can be toggled using .
CHAMBER SCREENS
– The Chamber screens have a large time and flow rate display, as shown
below. The arrow at the top of the screen indicates the connector used for that Chamber. The level
indicator at the bottom of the screen identifies the level of water in the Chamber.
The display will resemble the following:
Chamber 1
Chamber 2
CONNECTOR
LOCATION
See
Page 16
for special
graphics
Seconds
mL/hr
DATA
UNITS
Chamber Not Detected
LEVEL
INDICATOR
MESSAGE DISPLAY
OR DATA
Ready For Flow
Flow Rate Too High
Invalid Sensor Sequence
Chamber Needs Calibration
Low Battery
TYPICAL SCREEN DURING TEST
TYPICAL RESULTS SCREEN
12 GMC-I Messtechnik GmbH