Manual

GMC-I Messtechnik GmbH 137
16 PUSH/PRINT
The Push/Print function is a convenient way of sending test results directly to the IZYTRONIQ database by pressing a button on the test
device. The measurement results are placed in the index card for tests under the selected test object and can be saved there.
Global test device support
The test results from test devices for any categories, i.e. standards, do not have to be stored and saved in the same categories (e.g.
stationary or portable). For instance, measured values for a protective conductor test, measured by the test device PROFITEST PRIME,
can be assigned to a portable test object.
16.1 Conducting a push/print test
A push/print tests can only be conducted with a test device that is push/print-capable. A push/print measurement cannot be selected
if the test device does not have this function.
In order to conduct a push/print test, the test device and IZYTRONIQ must be set to push/print mode. This is completed by creating a
new push/print test in the index card for tests, which is found in the detailed view for the selected test object.
As soon as the button “ADD” is selected, IZYTRONIQ all connected push/print-capable test devices are in the operating mode push/
print. This opens a two-part push/print window and the IZYTRONIQ is ready to receive. The master data for the push/print test is located
in the upper section, where the name of the test must be added. The measured data transfer is shown in the lower section once the
measurement is complete.
From then on, measurements can be sent to the selected test object in the IZYTRONIQ at the push of a button on any device that is in
push/print mode.