Operation Manual

68 GMC-I Messtechnik GmbH
Select the position at which a new object will be added.
Use the  keys in order to select structural elements.
Change to the sub-level with the  key.
Go to the next page with the >> key
Create a new object.
Press the key in order to create a new object.
Select a new object from a list.
Select the desired object from the list with the  keys and
acknowledge with the  key.
Depending upon the profile selected in the test instrument’s
SETUP menu (see section 4.6), the number of object types may
be limited, and the hierarchy may be laid out differently.
Enter a designation.
Enter a designation and then acknowledge it by entering a 3.
Note
Acknowledge the standard or adjusted parameters
shown below, because the created designation will oth-
erwise not be accepted and saved.
Set Electrical Circuit Parameters
For example, nominal current values must be entered here for the
selected electrical circuit. Measuring parameters which have been
accepted and saved in this way are subsequently accepted by
the current measuring menu automatically when the display is
switched from the structural view to measurement.
Note
Electrical circuit parameters changed during structure
creation are also retained for individual measurements
(measurement without saving data).
If you change the electrical circuit parameters defined in the
structure of the test instrument, a warning is issued upon
saving, see error message on page 81.
16.3.2 Searching for Structural Elements
The search always starts with database, regardless of the currently
marked object.
Scroll up
Scroll down
Acknowledge selection /
Display object
Nextpage
change level
or ID number
Create object
Delete object
VA: show measurement data
Edit designation
Scroll up
Scroll down
Acknowledge selection
Select character
Select character
Accept character
Delete characters
Character selection:
3 Save object designation
A, a, 0, @
Select parameter
List of parameter settings
Acknowledge parameter selection
Acknowledge parameter setting
and return to page 1/3
Select parameter setting
in the database menu.
Scroll up
Scroll down
Acknowledge selection /
Display object
Menu selection  page 3/3
change level
or ID number