Operation Manual

GMC-I Messtechnik GmbH 3
1 Function selector switch
Switch positions:
SETUP: General device settings
Print out measured values and reports
Select data memory function
OFF: Switches the test instrument off *
TEST: Select measuring and test parameters,
and execute measurements and tests
2 : Select main menus and submenus, and adjust values
3 : Select main menus and submenus, and adjust values
4 Socket connector for RS 232 interface
5LCD panel
6 Signal lamp for test passed (green) / test failed (red)
7 MENU: Key for selecting and querying menus for setting
parameters, for returning to the main menu and for
stopping the measuring process
8 i/STORE: Before performing a measurement:
Key for querying context sensitive help
After performing a measurement:
Key for saving measured values and parameters to memory
9 START: Key for starting the selected test
10 Signal lamp: “testing ...” (yellow)
11 Pushbuttons (left and right) for releasing the handle
12 Pushbuttons (left and right) for releasing the cover
13 Cover
14 SECUTEST PSI printer module
15 Handle and bar function as a tilt stand
* During battery operation: battery is disconnected
During mains operation: transformer is still connected to the mains
16 Inlet plug for supply power with fuse compartment
17 Connector jack for guard cable (feature G1)
18 Connection for automotive charging adapter J1
19 Device base
Outside: With uptake for measurement cable, test probes and alligator clips
Inside: Uptake for guard cable with test probe (feature G1),
battery compartment
Attention!
!
Connect 5 m long Leadex 5000 accessory extension
cable (feature H1) to + measurement cable only!
Note
Maximum rated voltage to earth is 1000 V~, even if perma-
nently connected measurement cables for 2 kV~ CAT II
are permissible.