Operation Manual

GMC-I Messtechnik GmbH 27
B Prerequisites for Software Update or Exchange of Data
Ð Find the interface to which the MERISO PRIME+ is con-
nected.
Note
Always start this function first, before performing an update
or changing report templates. After starting this function,
WinProfi loads the report files required specifically for the
connected instrument.
Due to the fact that WinProfi has been created for use
with several types of test instruments, incorrect test
reports may otherwise be loaded, or erroneous options
may be made available.
Ð Querying information regarding current software version
C Transmitting a Software Update to the Test Instrument
Ð PC: Select Update all from the update menu. Follow the instruc-
tions which appear at the monitor.
Depending upon the utilized PC, updating takes from 1 to 2 min-
utes.
The green LED indicates that the instrument is ready to receive
data. If the PC and the test instrument are correctly synchronized,
the yellow LED lights up and the green LED goes out. The red
LED lights up during programming sequences. After transmission
has been completed, the LED goes out and the device is
restarted.
The message “Transmission done” appears at the PC.
Attention!
!
The instrument may not, under any circumstances, be
switched off during transmission, nor may the connec-
tion between the instrument and the PC be interrupted!
• Subsequently select “Language” (loading the respective lan-
guage), if applicable.