Operation Manual
GMC-I Messtechnik GmbH 19
3.3 Mounting the MERISO PRIME+ with Feature B1/B2 to the
Trolley (feature D1).
Ð Set the complete unit consisting of test instrument and
high-voltage module onto the trolley’s platform (1) such that
the cover of the test instrument can still be opened.
Ð Secure the test instrument’s handle to the vertical supports
with the handle clamps (3). Loosen the screws in the handle
clamps (9) to this end with a 4 mm hollow hex wrench.
Ð Push the handle clamps (3) over the handle and retighten the
screws (9).
Ð Wind the two cables from the safety test probes onto the bot-
tom cable uptake (2 at bottom).
Ð Then wind the two cables from the test instrument’s test
probes onto the top cable uptake (2 at top).
Ð Secure the cables and the test probes with the included rub-
ber straps (12).
Attention!
!
Observe regulations for portable test equipment in ac-
cordance with DIN VDE 0104 (3.6).
Note
Wind the test cables from the safety test probes onto the
provided cable uptakes at the back of the trolley after
each use. Test cables may not, under any circumstances,
be mechanically stressed or kinked, because impaired
insulation characteristics may otherwise result. Do not
forget that externally caused damage is not always rec-
ognizable.
Attention!
!
Inspect the test cables for mechanical damage before
placing the high-voltage module into service each time it
is used.
10
11
8
2
3
2
5
6/7
1
4
9
Item Designation Qty. Order Number
1 Base 1 3-117-193-01
2 Cable uptake 2 3-326-653-01
3 Handle clamp 2 3-326-652-01
4 Cover 2 3-164-609-01
5 Wheel 2 3-419-038-01
6 Washer 4 3-740-013-01
7
Retaining ring
2 3-743-024-59
8 Screw 6 3-712-007-10
9 Hex nut 6 3-730-119-12
10 Screw 2 3-716-018-24
11 Trolley frame 1 3-121-111-01
12 Rubber strap 2 3-326-627-01
13
Protective cover
1 3-171-302-01
Caddy 204 Trolley