Operation Manual

GMC-I Messtechnik GmbH 5
as well as requirements in accordance with VDE 0701-0702:
Repair, modification and testing of electrical devices
The test instrument is especially well suited for:
• Systems installation
• Initial start-up
• Periodic testing
• Troubleshooting in electrical systems
All required measurements can be performed for approval reports (e.g. for
ZVEH) with the help of a set consisting of the PROFiTEST C and the
METRISO C.
Measurement values can be transmitted to a PC for printing and archiving
via the integrated IR data interface at the METRISO C. This is especially
important where product liability is concerned.
The following measurements and tests can be performed with the METRISO C:
• Insulation resistance
• Low-value resistance
• Contact current
• Voltage and frequency
• Temperature and humidity (with accessories)
The following can also be measured with a shielded measurement cable:
• Conductivity of floor coverings for electrostatic discharge
2 Safety Features and Precautions
The electronic test and measuring instrument METRISO C has been built
and tested in accordance with the following standards:
IEC 61010-1:2010, EN 61010-1:2010, VDE 0411-1:2011
IEC 61557-1, -2, -4, -10
DIN EN 61557-1:2007, -2:2007, -4:2007, -10:2001
VDE 413-1:2007, -2:2008, -4:2007, -10:2001
The safety of the user and the instrument is guaranteed provided that the
instrument is used for its intended purpose.
Read the operating instructions carefully and thoroughly before using your
instrument, and observe all instructions included therein.
The measuring and test instrument may not be used:
• If the battery compartment cover has been removed
• If external damage is apparent
• With damaged connector cables or measuring adapters
• If it no longer functions flawlessly
• After excessive stress due to transport
• While the batteries are being charged
Meanings of Symbols on the Instrument
Warning concerning a point of danger
(Attention: observe documentation!)
Protection class II device
CAT II Measuring category I I device
9 V DC charging socket for NA102 charging adapter
(
part no. Z5 01N)
Indicates EC conformity
This device and the inserted (rechargeable) batteries may not
be disposed of with the trash.
Further information regarding the
WEEE mark can be accessed on the Internet at www.gossen-
metrawatt.com under the search term ’WEEE’
.
Opening of Equipment / Repair
The equipment may be opened only by authorized service personnel to
ensure the safe and correct operation of the equipment and to keep the
warranty valid.
Even original spare parts may be installed only by authorized service per-
sonnel.
In case the equipment was opened by unauthorized personnel, no war-
ranty regarding personal safety, measurement accuracy, conformity with
applicable safety measures or any consequential damage is granted by
the manufacturer.
!
–