Operation Manual
GMC-I Messtechnik GmbH 49
Device and Measuring Parameters
6.1 Paths to the Various Parameters 6.2 List of All Parameters
bAtt:
0CCvP:
dAtE
/t iME:
caldat/
uer
tEMPintern:
1nFo
SEnd
SET
StorE
StArt
StoP
000.0
CLEAr
StArt/
StoP
hyst
rate
trig
t
.store
Submenus / parameters ↓
time
date
addr
Com ir
irStb
apoff
Clip
beep
tempunit
tempintern
beeper
Main Menus →
Query Set
Set
Set
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
1nfo
MEASURE
SETUP
020
.
00
V
DC
AC
TRMS
Acknowledge
FUNC
ENTER
Acknowledge
FUNC
ENTER
Acknowledge
FUNC
ENTER
Com bt
bt pin
M248B:
IR
Parameter
Page: Header
Addr
57: Configuring Interface Parameters
APoFF
51: APoFF – Specified Time for Automatic Shutdown and Continuous ON
bAtt 50: bAtt – Query Battery Voltage
bEEP 52: bEEP – Set Limit Value for Continuity Testing
beeper on
/
off
52: bEEPEr on/oFF – Activate/Deactivate Acoustic Signals
bt pin
57: bt Pin – Allocating the pin for the Bluetooth interface (M248B)
caldat 50: cALdAt – Query Calibration Date
CLEAr
24: Measurement Data Recording
CLiP 45: Direct and Pulsating Current Measurement with Current Clamp Sen-
sor, A DC and A (DC+AC)
Com bt 57: Interface Selection for METRA HIT ULTRA BT (M248B)
CoM ir 57: Interface Selection for METRA HIT ULTRA BT (M248B)
dAtE 50: dAtE – Query Date, 51: dAtE – Enter Date
EMpty
24: Measurement Data Recording
hyst
53: HYSt – Hysteresis (parameter for memory mode operation)
1nfo 50: Querying Parameters – InFo Menu
irStb
57: Configuring Interface Parameters
1tEMP 50: ItEMP intErn – Query Reference Temperature
0CCvP
24: Measurement Data Recording
rAtE
53: rAtE – Set Transmission and Storage Rate
SEnd 56: Activating the Interface
SET 51: Entering Parameters – SETUP Menu
StArt
24: Measurement Data Recording
StoP
store
temp intern 50: ItEMP intErn – Query Reference Temperature
temp unit 52: tEMP unit – Select a Unit of Measure for Temperature
t iME 50: tiME – Query Time, 51: tiME – Set Time
trig 54: triG – Trigger Conditions (parameters for memory mode operation)
tstore 54: tStorE – Recording Time (parameter for memory mode operation)
uEr
50: vErSion – Query Firmware Version