User Manual
GMC-I Messtechnik GmbH 51
Device and Measuring Parameters
6.4 Entering Parameters – SETUP Menu
tiME – Set Time
Entering the correct time makes it possible to acquire measured
values in real-time.
1nFo ... SET t iME
t iME SET: 10:24:18 (hh:mm:ss)
Date and time must be reentered after replacing the batteries.
dAtE – Enter Date
Entering the current date makes it possible to acquire measured
values in real-time.
1nFo
... SET t iME ... dAtE
datE SET: 20.06 (DD: day . MM: month)
year SET: 2012 (YYYY: year)
Date and time must be reentered after replacing the batteries.
Addr – Set Device Address
See section 7.2 on page 57.
irStb – Status of the Infrared Receiver in the Stand-By Mode
See section 7.2 on page 57 regarding settings.
CoM ir / CoM bt – Interface Operating System Infrared / Bluetooth
Refer to section 7.2 on page 57 for instructions on switching bet-
ween the two systems.
bt pin – Pin for Bluetooth Interface
Refer to section 7.2 on page 57 on setting instructions.
APoFF – Specified Time for Automatic Shutdown and Continuous ON
The instrument is switched off automatically if the measured value
remains unchanged for a long period of time and if none of the
keys or the rotary switch have been activated before the specified
time “APoFF” (entered in minutes) has elapsed.
If the on setting is selected, the multimeter is set to continuous op-
eration and
ON appears in the display to the right of the battery
symbol. In this case, the multimeter can only be switched off
manually. The “on” setting can only be canceled by changing the
respective parameter, or by switching the instrument off manually.
In this case, the parameter is reset to 10 minutes.
1nFo
... SET t iME ... APoFF
APoFF SET: 10 ... 59 min on
(10 minutes = default setting)
Note
The auto power off function (APoFF parameter) is deactivated
when dangerous touch voltage is applied.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER