User Manual

48 GMC-I Gossen-Metrawatt GmbH
Device and Measuring Parameters
6.3 Querying Parameters – InFo Menu (as moving letters)
bAtt – query battery voltage
1nFo bAtt
: 2.75 V.
vErSion – query firmware version
1nFo bAtt:  vErSion : 2.09
ItEMP – query reference temperature
The temperature of the internal reference junction is measured with a
temperature sensor in close proximity to the input sockets.
1nFo bAtt:  ...  1tEMP : 24 ° C
dAtE – query date
1nFo bAtt:  ...  dAtE : 31 . 12 . 05 (DD.MM.YY)
D = day, M = month, Y = year
Date and time must be reentered after replacing the batteries.
tiME – query time
1nFo bAtt
:  ...  t iME : 13 : 46 : 56
(hh:mm:ss)
h = hours, m = minutes, s = seconds
Date and time must be reentered after replacing the batteries.
OCCUP – query memory occupancy (METRAHIT⏐X-TRA⏐OUTDOOR only)
1nFo bAtt
:  ...  0CCUP : 000 . 0 %
6.4 Entering Parameters – SETUP Menu
rAtE – set the sampling rate (METRAHIT⏐X-TRA⏐OUTDOOR only)
The sampling rate specifies the time interval after which the
respective measured value is transmitted to the interface, or to
measured value memory.
Any one of the following sampling rates can be selected:
00:00.1, 00:00.2, 00:00.5, 00:01.0, 00:02.0, 00:05.0
[h:mm:ss.t] (h = hours, m = minutes, s = sec.,
t = tenths of a sec. )
0:00:10, 0:00:20, 0:00:30, 0:00:40, 0:00:50, 0:01:00, 0:02:00,
0:05:00, 0:10:00, 0:20:00, 0:30:00, 0:40:00, 0:50:00, 1:00:00,
2:00:00, 3:00:00, 4:00:00, 5:00:00, 6:00:00, 7:00:00, 8:00:00,
9:00:00
Setting the Sampling Rate
1nFo  ...  SET rAtE
00:00.1 ... 00:00.5 ... 9:00:00 
(00:00.5 = 0.5 seconds = default value)
0.diSP – show/hide leading zeros
This parameter determines whether or not leading zeros will
appear in the measured value display.
1nFo  ...  SET rAtE  ...  0.diSP
0000.0 : with leading zeros (default setting)
0.0 : leading zeros suppressed

MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER