User Manual

4 GMC-I Gossen-Metrawatt GmbH
Standard Equipment Contact Persons
Recalibration Service
We calibrate and recalibrate all instruments supplied by GMC-I
Gossen-Metrawatt GmbH, as well as other manufacturers, at our
service center, for example after one year within the framework of
your test equipment monitoring program, as well as prior to use
etc.
Repair and Replacement Parts Service
DKD Calibration Laboratory* and Rental Instrument Service
If required please contact:
GMC-I Gossen-Metrawatt GmbH
Service Center
Thomas-Mann-Str. 20
90471 Nürnberg, Germany
Phone: [phone]
Fax: [phone]
e-mail: [e-mail]
This address is only valid in Germany. Please contact our
representatives or subsidiaries for service in other countries.
* Calibration laboratory for measured electrical quantities,
DKD – K – 19701, accredited in accordance with
DIN EN ISO/IEC 17025:2005
Accredited quantities: direct voltage, direct current value, direct current
resistance, alternating voltage, alternating current value, AC active
power, AC apparent power, DC power, capacitance, frequency,
temperature
Competent Partner
GMC-I Gossen-Metrawatt GmbH is certified in accordance with
DIN EN ISO 9001:2000.
Our calibration laboratory is accredited per DIN EN ISO/IEC
17025 by the Physikalisch-Technischen Bundesanstalt (German
Federal Institute of Physics and Metrology) and the Deutscher
Kalibrierdienst (German Calibration Service) under registration
number DKD–K–19701.
We offer a complete range of expertise in the field of metrology:
from test reports and factory calibration certificates, right on up to
DKD calibration certificates.
Our spectrum of offerings is rounded out with free test equipment
management.
As a full service calibration lab, we can calibrate instruments from
other manufacturers as well.