Operation Manual

GMC-I Messtechnik GmbH 53
Device and Measuring Parameters
CLIP – set current clip factor
See chapter 5.9.3 and chapter 5.9.4.
r _SL – set limit value for protective conductor resistance
1nFo
 ...  SET rAtE  ...  r _sl
> 100, 200 Ω, 2 ... 3 kΩ, 0L 
(2 = default setting)
CAP – scaling factor for cable length measurement (capacitive linear
electric constant)
1nFo
 ...  SET rAtE  ...  CAP
010 nF . . . 100 nF . . . 500 nF 
(100 nF = default setting)_
6.5 Default Settings
Previously entered changes can be undone, and the default
settings can be reactivated. This may be advisable under the
following circumstances:
• after the occurrence of software or hardware errors,
• if you are under the impression that the multimeter does not
work correctly.
Ð Disconnect the device from the measuring circuit.
Ð Remove the batteries temporarily (see also chapter 9.2).
Ð Simultaneously press and hold the and
keys, and connect the battery at the same time.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
ZERO
ESC
ON / OFF
LIGHT