Operation Manual

52 GMC-I Messtechnik GmbH
Device and Measuring Parameters
bEEP – set limit value for continuity testing
1nFo
 ...  SET rAtE  ...  bEEP
1, 10, 20, 30, 40, 90 Ω

(10 Ω = default setting)
irStb – status of the infrared receiver in the stand-by mode
See chapter 7.2 on page 55 regarding settings.
Addr – set device address
See chapter 7.2 on page 55.
dAtE – enter date
Entering the current date makes it possible to acquire measured
values in real-time.
1nFo
 ...  SET rAtE  ...  dAtE
31.12 (DD: day . MM: month)
 
2005 (YYYY: year)
 
Date and time must be reentered after replacing the batteries.
tiME – set time
Entering the correct time makes it possible to acquire measured
values in real-time.
1nFo  ...  SET rAtE  ...  t iME
10:24 (hh:mm)  
Date and time must be reentered after replacing the batteries.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER