Operation Manual

GMC-I Messtechnik GmbH 51
Device and Measuring Parameters
6.4 Entering Parameters – SETUP Menu
rAtE – set the sampling rate
The sampling rate specifies the time interval after which the
respective measured value is transmitted to the interface, or to
measured value memory.
Any one of the following sampling rates can be selected:
[mm:ss.t]: 00:00,1, 00:00,2, 00:00.5, 00:01,0, 00:02,0, 00:05.0
[h:mm:ss.t] (h=hours, m=minutes, s=seconds
, z=tenths of a sec. ):
0:00:10, 0:00:20, 0:00:30, 0:00:40, 0:00:50, 0:01:00, 0:02:00,
0:05:00, 0:10:00, 0:20:00, 0:30:00, 0:40:00, 0:50:00, 1:00:00,
2:00:00, 3:00:00, 4:00:00, 5:00:00, 6:00:00, 7:00:00, 8:00:00,
9:00:00
Setting the Sampling Rate
1nFo  ...  SET rAtE
00:00.1 ... 00:00.5 ... 9:00:00 
(00:00.5 = 0.5 s = default value)
0.diSP – show/hide leading zeros
This parameter determines whether or not leading zeros will
appear in the measured value display.
1nFo  ...  SET rAtE  ...  0.diSP
0000.0 : with leading zeros (default value)
0.0 : leading zeros suppressed

A.diSP – analog display: select display mode
One of two different display modes can be selected for the analog
display:
• bArG: bar graph
• Po int: pointer
1nFo
 ...  SET rAtE  ...  A.d iSP
bArG / Po int

(po int = default setting)
APoFF – specified time for automatic shutdown and continuous ON
The instrument is switched off automatically if the measured value
remains unchanged for a long period of time and if none of the
keys or the rotary switch have been activated before the specified
time “APoFF” (entered in minutes) has elapsed.
If the on setting is selected, the multimeter is set for long-term
measurement and
ON appears in the display to the right of the
battery symbol. In this case, the multimeter can only be switched
off manually. The “on” setting can only be cancelled by changing
the respective parameter, and not by switching the instrument off.
1nFo
 ...  SET rAtE  ...  APoFF
10 ... 59 min on

(10 minutes = default setting)
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER