Operation Manual

58 GMC-I Messtechnik GmbH
Device and Measuring Parameters
dAtE – enter date
Entering the current date makes it possible to acquire measured
values in real-time.
1nFo
 ...  SET rAtE  ...  dAtE
31.12 (DD: day . MM: month)
 
2005 (YYYY: year)
 
Date and time must be reentered after replacing the batteries.
tiME – set time
Entering the correct time makes it possible to acquire measured
values in real-time.
1nFo  ...  SET rAtE  ...  t iME
10:24 (hh:mm)  
Date and time must be reentered after replacing the batteries.
CLIP – set current clip factor
See chapter 5.7.3 and chapter 5.7.4.
r _SL – set limit value for protective conductor resistance
1nFo
 ...  SET rAtE  ...  r _sl
> 100, 200 Ω, 2 ... 3 kΩ, 0L 
(2 = default setting)
CAP – scaling factor for cable length measurement (capacitive linear
electric constant)
1nFo
 ...  SET rAtE  ...  CAP
010 nF . . . 100 nF . . . 500 nF

(100 nF = default setting)_
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER