User manual
GMC-I Messtechnik GmbH 53
Device and Measuring Parameters
6.1 Paths to the Various Parameters 6.2 List of All Parameters
bAtt
:
uers
ion
:
1temp
dAtE
:
t iME
:
0CCvP
:
1nFo
tEMPSEnd SET StorE
StArt
StoP
000. 0
CLEAr
StArt
StoP
Sub-Menus / Parameters
rAtE
resol *
0
.d iSP
a
.d iSP
vpm *
CL iP
APoFF
v_1so
bEEP
irStb
Addr
dAtE
t iME
C
F
Main Menus
Query Set Set Set Set
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
01nfo
MEASURE
SETUP
020
.
00
V
DC
AC
TRMS
Selection
FUNC
ENTER
Selection
FUNC
ENTER
Selection
FUNC
ENTER
Selection
FUNC
ENTER
* Function only available with customer-specific variant
Parameter
Page: Header
0.d iSP 55: 0.diSP – show/hide leading zeros
a.disp
55: A.diSP – Select display mode for the analog display
Addr
59: Configuring Interface Parameters
APoFF
56: APoFF – specified time for automatic shutdown and continuous ON
bAtt
54: bAtt – query battery voltage
bEEP
56: bEEP – set limit value for continuity testing
CLEAr
24: Measurement Data Recording
CL IP
49: Direct and Pulsating Current Measurement with Clip-On Current Sensor
A DC and A (DC+AC)
50: Alternating Current Measurement with Clip-On Current Sensor, A AC and Hz
dAtE
54: dAtE – query date, 57: dAtE – enter date
EMpty
24: Measurement Data Recording
1nfo
54: Querying Parameters – InFo Menu (as moving letters)
irStb
59: Configuring Interface Parameters
itemp
54: ItEMP – query reference temperature
0CCvP
24: Measurement Data Recording
rAtE
55: rAtE – set the sampling rate
resol
55: rESoL – high resolution for V DC and W (customer-specific function)
SEnd
58: Activating the Interface
SET
55: Entering Parameters – SETUP Menu
StArt
24: Measurement Data Recording
StoP
store
tEMP
33: Temperature Measurement: Temp RTD and Temp TC
t iME
54: tiME – query time, 57: tiME – set time
v1so
56: U_ISo – select test voltage
vpm
56: RPM – revolutions per minute (customer-specific function)
uErS
ion
54: vErSion – query firmware version