User Manual

GMC-I Messtechnik GmbH 53
Device and Measuring Parameters
dAtE – enter date
Entering the current date makes it possible to acquire measured
values in real-time.
1nFo ... SET rAtE ... dAtE
31.12 (DD: day . MM: month) 
2005 (YYYY: year)

Date and time must be reentered after replacing the batteries.
tiME set time
Entering the correct time makes it possible to acquire measured
values in real-time.
1nFo
... SET rAtE ... t iME
10:24 (hh:mm)

Date and time must be reentered after replacing the batteries.
6.5 Default Settings
Previously entered changes can be undone, and the default
settings can be reactivated. This may be advisable under the
following circumstances:
after the occurrence of software or hardware errors,
if you are under the impression that the multimeter does not
work correctly.
Disconnect the device from the measuring circuit.
Remove the batteries temporarily (see also chapter 9.2).
Simultaneously press and hold the and
keys, and connect the battery at the same time.
A sequence of acoustic signals consisting of two immediately
consecutive tones acknowledges successful resetting.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
ZERO
ESC
ON / OFF
LIGHT