User Manual

74 GMC-I Messtechnik GmbH
Device and Measuring Parameters
Actual measurement is always executed using the sampling rate
selected in “Store > rAtE”.
1nFo
 ...  store  ...  trig
trig set : sto-ou / sto-in / off 
l_trig set : -300000 ... +300000

h_trig set : -300000 ... +300000

tStorE – Recording Time (parameter for memory mode operation)
This parameter determines whether or not measured values will be
recorded for a limited time only. If recording time will be limited, its
duration can be entered in hours, minutes and seconds. “On”
means unlimited recording time.
1nFo  ...  store  ...  t .store
t .store set : on /99:00:00 (hh:mm:ss)

6.5 Default Settings (factory settings) – Reset
Previously entered changes can be undone, and default settings
can be restored. This may be advisable under the following cir-
cumstances:
• After the occurrence of software or hardware errors
• If you are under the impression that the multimeter does not
work correctly
Ð Disconnect the device from the measuring circuit.
Ð Remove the batteries temporarily (see also section 9.2).
Ð Simultaneously press and hold the and
keys, and connect the battery at
the same time.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
ZERO
ESC
ON / OFF
LIGHT