User Manual

GMC-I Messtechnik GmbH 65
Device and Measuring Parameters
bLiGht – Disable Deactivation of Background Illumination
If necessary, automatic deactivation of background illumination
can be disabled with this parameter setting or via the interface.
1nFo
 ...  SET system
system t iME
 ...  system blight
blight set: apoff / on

Note
Each time the instrument is switched on, the bLiGht
parameter is reset to bLiGht = APoFF!
0.diSP – Show/Hide Leading Zeros
This parameter determines whether or not leading zeros will
appear in the measured value display.
1nFo
 ...  SET system
system t iME
 ...  system 0.diSP 0.diSP set:
00000.0 : with leading zeros (default value)
0.0 : leading zeros suppressed

6.4.2 EVEntS Submenu
EVEntS – Event Counter Sampling Rate and Trigger Thresholds
An event is recorded whenever at least one measured value has
fallen short of the L-trig threshold, and subsequently at least one
measured value has exceeded the H-trig threshold. Voltage signals
with a repetition frequency of less than 500 Hz, or less than 2 Hz,
are recorded (events rate of 0.001 or 0.5 seconds).
1nFo  ...  SET system  ...  events
events trig/events rate DC

h-trig set : -60000 ... +60000 
l-trig set : -60000 ... +60000 
events rate : 0 ..001 /0..5 s 
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER