User Manual

GMC-I Messtechnik GmbH 63
Device and Measuring Parameters
6.3 Querying Parameters – InFo Menu (as moving letters)
bAtt – Query Battery Voltage
1nFo bAtt: 2.75 V.
OCCUP – Query Memory Occupancy
1nFo bAtt: s ... s 0CCvP: 000.0 %
tiME /dAtE – Query Time/Date
1nFo bAtt:  ...  dAtE: 31 . 12 . 2009 (DD.MM.YY)
t iME: 13:46:56 (hh:mm:ss)
h = hours, m = minutes, s = seconds
D = day, M = month, Y = year
Date and time must be reentered after replacing the batteries.
vErSion /cALdAt – Query Firmware Version and Calibration Date
1nFo bAtt:  ...  caldat : 31 . 02 . 10
VEr
: 1.00
tEMP intErn – Query Reference Temperature
The temperature of the internal reference junction is measured with a tempera-
ture sensor in close proximity to the input sockets.
1nFo bAtt:
 ...  1tEMP intern : 24 °C
Swell 69: SwELL and diP Limit – Trigger Thresholds for Brief Overvoltages and Undervoltages SEt/MAinS PQ
system 64: SYSTEM Submenu SEt/SYStEM All
tEMPintern 63: tEMP intErn – Query Reference Temperature InFo Temp TC/RTD
tEMPintern
67: tEMP intErn/ExtErn – Select Internal or External Reference Junction External Reference Junction: Specified Temperature SEt Temp TC/RTD
tEMpunit 66: tEMP unit – Select a Unit of Measure for Temperature SEt Temp TC/RTD
t iME 63: tiME /dAtE – Query Time/Date, 64: tiME – Set Time SEt/SYStEM All
trig 73: triG – Trigger Conditions for Memory Mode Operation StorE Memory Mode Operation
tstore 74: tStorE – Recording Time (parameter for memory mode operation) StorE Memory Mode Operation
vErSion 63: vErSion /cALdAt – Query Firmware Version and Calibration Date InFo Parameters query
Menus
Parameters
Page: Header Menu / Submenu Function / Switch Position
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER