User Manual

62 GMC-I Messtechnik GmbH
Device and Measuring Parameters
6.2 List of all Parameters, Main Menus and Submenus
Menus
Parameters
Page: Header Menu / Submenu Function / Switch Position
0.disp 65: 0.diSP – Show/Hide Leading Zeros SEt/SYStEM All
Addr 76: Configuring Interface Parameters SEt/SYStEM Interface operation
APoFF 64: APoFF – Specified Time for Automatic Shutdown and Continuous On SEt/SYStEM All except PQ, W and Wh
bAtt 63: bAtt – Query Battery Voltage InFo Parameters query / all
bEEP 66: bEEP – Set Limit Value for Continuity Testing SEt
blight 65: bLiGht – Disable Deactivation of Background Illumination SEt/SYStEM All
Cap 66: CAP –
Scaling Factor for Cable Length Measurement (capacitive linear electric constant) SEt m
CLEAr 22: Measurement Data Recording – Memory Mode Operation, STORE Menu Function StorE Memory mode operation
CLAMP 66: CLiP – Set Transformation Ratio (current clamp factor) SEt A
dAtE 63: tiME /dAtE – Query Time/Date, 64: dAtE – Enter Date SEt/SYStEM All
dBrEF 66: dbrEF – Set Reference Value for Alternating Voltage Level Measurement SEt dB
demand time
68: dEMAnd tiME – Time Interval for Mean Value Generation (parameter for power measurement in memory mode) SEt/EnErGY W/VA/VAr
diplimit 69: SwELL and diP Limit – Trigger Thresholds for Brief Overvoltages and Undervoltages SEt/MAinS PQ
energy 68: EnErGY Submenu SEt/EnErGY W/VA/VAr
energy Store
68: EnErGY StorE – Scope of Stored Values for Power and Energy Measurements SEt/EnErGY W/VA/VAr
events
65: EVEntS – Event Counter Sampling Rate and Trigger Thresholds SEt/EVEntS V V
harm
71: HArM – Harmonic Analysis Parameter SEt/HArM A/~ (THD)
hivolt
69: LoVolt and HiVolt – Trigger Thresholds SEt/MAinS PQ
hyst 73: HYSt – Hysteresis (parameter for memory mode operation) StorE Memory mode operation
1nfo 63: Querying Parameters – InFo Menu (as moving letters) InFo Parameters query / all
irStb 76: Configuring Interface Parameters SEt/SYStEM Interface
lovolt 69: LoVolt and HiVolt – Trigger Thresholds SEt/MAinS PQ
mains
69: MAinS – Mains Disturbance Recording Parameter SEt/MAinS PQ
mains.f
69: MAinS.F – Select Line Frequency SEt/MAinS PQ
mains Range 69: MAinS rAnGE – Select a Measuring Range for Mains Disturbance Recording SEt/MAinS PQ
0CCvP 63: Querying Parameters – InFo Menu (as moving letters) InFo Memory occupancy / all
rAtE
72: rAtE – Transmission and Storage Rate SEt/EnErGY Memory mode operation
r_sl
66: r_SL – Set Limit Value for Low-Resistance Measurement SEt
Ω
SEnd 75: Activating the Continuous Transmission Mode SEnd Interface operation
SET 64: Entering Parameters – SETUP Menu SEt Parameters menu
StArt
22: Measurement Data Recording – Memory Mode Operation, STORE Menu Function
StorE
Memory mode operationStoP StorE
Store 72: StorE Submenu – Parameters for Memory Mode Operation StorE