User Manual

60 GMC-I Messtechnik GmbH
Device and Measuring Parameters
6 Device and Measuring Parameters
The instrument’s “SET” mode (menu mode) makes it possible to set
operating and measuring parameters, query information and acti-
vate the interface.
Ð The menu mode is accessed by pressing the MEASURE | SETUP
key, assuming that the instrument is switched on and set to
“Measure” (measuring mode operation).
“1nFo” appears at the display.
Ð The main menus, i.e. the “SET”, “ SEnd” and “StorE” menus, are
accessed, and the display is returned to “1nFo” by repeatedly
activating the
  keys (in any direction).
Ð After selecting the desired main menu, sub-menus are ac-
cessed by pressing the FUNC | ENTER key.
Ð The desired parameter is selected by repeatedly pressing the
 keys.
Ð In order to change a parameter, acknowledge it with the
FUNC | ENTER key, after which “SET” appears in the right-hand
auxiliary display.
Ð The
  keys can be used to position the cursor at the entry
position.
The desired value is selected with the help of the
 keys.
Ð Changes can only be accepted with the FUNC | ENTER key, after
which “SET” is cleared from the display.
Ð You can return to the sub-menu without making any changes
by pressing the ZERO | ESC key, and to the main menu by
pressing the ZERO | ESC key once again.
After repeatedly pressing the MEASURE | SETUP key (without first tur-
ning the multimeter off), you can return to the last selected menu
or parameter from the measuring mode.
The instrument is returned to measuring mode operation by pres-
sing the MEASURE | SETUP key.
Example: Setting Time
1nFo
 ...  set System
System t iME10:24:35
tiME set: 10:24:35 (hh:mm:ss)
 
Setting hours and minutes:
  Advance to desired entry position.
 Change the setting, the entry position blinks.
Press and hold the key
to change the setting rapidly.
The new time setting is activated after
acknowledgment.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER