User manual

METRAwin 90 - Operating Instructions
GOSSEN METRAWATT 24
3.6 TEST Operating Mode
3.6.1
Creating a Calibration Procedure
►
Click the [TEST] button in the control bar.
⇒
The first procedure line appears in the workspace which consists of an upper
“output line” for programming the calibration signal and a lower “input line” for
the expected results at the device to be calibrated and the allowable tolerances.
►
Double click into the procedure line’s Step field in order to select the desired
simulation function at the calibrator.
►
Select the desired output function and operating mode, and acknowledge by
clicking the [OK] button.
⇒
A control panel for configuring the parameters of the selected function then
appears in the workspace:
►
Select the parameters to be configured and enter the setpoint value either
numerically or by adjusting the displayed value at the corresponding decimal
place with the [+] and [-] keys. Acknowledge your entry with [OK].
⇒
The
Test Parameters
dialog box appears.