User manual

METRAwin 90 - Operating Instructions
GOSSEN METRAWATT 13
►
Additional options can be selected via a further dialog box:
•
Test Header Only loads only the teat report header parameters of the selected
file for a previously opened/created calibration procedure.
•
Test Procedure loads the calibrating procedure only without results.
•
Test Procedure With Results loads the calibration procedure along with the
included calibration results.
i
Note 1
When a file is opened which contains data from a calibrator other the one currently selected
under
Device Type in the Setup menu, the program switches to the current device type
after acknowledgement of the prompt which appears in this case. If this program variant is not
available, i.e. if the required device
-specific program module has not been installed or
enabled, the following message appears
“Device is not installed - <device type designation>”.
i
Note 2
It
’s not possible to open more than one calibration procedure file at a time.
i
Note 3
Further Information regarding elements in this dialog box can be accessed via the direct help
function: First click
? in the title bar of the window, and then click the element for which help
is required. A popup window with an appropriate explanation appears. This explanation can
also be display
ed by clicking the element with the right mouse button and then clicking Direct
help
in the menu which then appears.
File:
Save
After clicking
Save in the file menu, temporary procedure data are permanently
saved to a data storage medium so that they
’re still available later on.
Figure
3.3.1-b: Dialog Box for Saving Procedure Files