User manual

GMC-I Messtechnik GmbH 27
16 Accessories
Interface adapter USB-HIT
Bidirectional transmission between the IR and the USB inter-
face.
The driver to be installed assigns a virtual COM interface to
the instrument. It is not possible to set up a multi-channel
system with this adapter.
METRAwin10 PC Analysis Software
METRAwin10
PC software is a multilingual, measurement data
logging program* for recording, visualizing, evaluating and
documenting measured values from METRAHIT multimeters.
Details on the system requirements are given in the installation
instructions of
METRAwin10 /METRAwin 45.
* runs under any IBM compatible Windows operating system
General
The extensive accessories available for our measuring
instruments are checked for compliance with currently valid
safety regulations at regular intervals, and are expanded as
required for new applications. Currently up-to-date
accessories which are suitable for your measuring instrument
are listed at the following web address along with photo,
order number, description and, depending upon the scope of
the respective accessory, data sheet and operating
instructions: www.gossenmetrawatt.com
(english Products  Measuring Technology – Portable 
Multimeters  METRA HIT ...  Accessories).
17 Repair and Replacement Parts Service,
Calibration Center* and Rental Instrument Service
If required please contact:
GMC-I Service GmbH
Service Center
Thomas-Mann-Str. 20
90471 Nuremberg • Germany
Phone [phone]
Fax [phone]
E-Mail [e-mail]
www.gmci-service.com
This address is only valid in Germany.
Please contact our representatives or subsidiaries for service
in other countries.
* DAkkS Calibration Laboratory for Electrical Quantities
D-K-15080-01-01 accredited as per DIN EN ISO/IEC 17025
Accredited quantities: direct voltage, DC value, DC resistance,
alternating voltage, AC value, AC active power, AC apparent power,
DC power, capacitance, frequency and temperature
Competent Partner
GMC-I Messtechnik GmbH is certified per DIN EN ISO 9001.
Our DAkkS calibration laboratory is accredited by the Deut-
sche Akkreditierungsstelle GmbH (National accreditation
body for the Federal Republic of Germany) in accordance
with DIN EN ISO/IEC 17025 under registration number
D-K-15080-01-01.
Our competence in the field of metrology covers test reports,
Proprietary Calibration Certificates as well as DAkkS Calibration
Certificates.
Our range of services is complemented by our Test Equipment
Management service which is provided free of charge.
An on-site DAkkS calibration station is an integral part of our
service department. If any faults are detected during calibra-
tion, our specialists are able to carry out the necessary
repairs with original replacement parts.
Needless to say, in our function as calibration laboratory, we
calibrate all instruments, irrespective of the manufacturer.
DAkkS Calibration Certificate Reprints
If you order a DAkkS calibration certificate reprint for your
instrument, please provide us with the reference numbers
indicated in the upper and lower most fields of the calibration
seal. We do not need the instrument’s serial number.