Operation Manual

GMC-I Messtechnik GMBH 17
GB
8 Using the Menus – from the Initial InFO Menu to
Operating and Measuring Parameters
Menu-driven operation via the initial „1NF0 “ menu allows
the user to query online help, activate the memory and
query memory occupancy, activate the interface and
configure device parameters.
➭ The initial „1NF0 “ menu is accessed by simultaneously
pressing and holding the MENU/ESC and ON|OFF keys
with the instrument switched on, until „1NF0 “ appears
at the display.
➭ The display can be switched from the main „1NF0 “
menu to the other main menus including “store“,
“memo”, “ send” and “set”, and then back to the „1NF0 “
menu, by repeatedly pressing the  keys.
➭ After accessing the desired main menu, the associated
submenus are opened by activating the  key.
➭ The desired parameter or the desired function is se-
lected by repeatedly pressing the  keys.
➭ Acknowledge with the  key in order to change the
corresponding parameter or parameters.
➭ After the desired digit has been selected with the 
keys and the value has been adjusted with the 
keys, the next digit is accessed with the  key, or the
display is returned to the start menu or switched to the
next submenu.
➭ The measuring mode is started by repeatedly pressing
the MENU/ESC key until the measuring display appears.
➭ The milliohmmeter is switched off by pressing and
holding the ON|OFF key until the display goes blank.
The following pages include an overview of the menu
structure.
8.1 Sampling rAtE
The sampling rate specifies the time interval after which the
respective measured value is transmitted to the interface or
to measured value memory. See page 24 for possible set-
tings. The lower limit of the sampling rate which cannot be
fallen short of, is 0.5 s.