User manual

GMC-I Messtechnik GmbH 11
➭ Key DATA > Menu MEASURED VALUE NO.
In this switch position all measured values of
a DUT are shown in a consecutive, numeri-
cal sequence in the order of their recording.
➭ Key CLR > Menu DUT DEL ?
Pressing key „S“ (6) deletes the current
memory location, i.e. all data for the selected
DUT. As a preventive measure against acci-
dental deletion you have to keep key „S“ (6)
pressed for about half a second before the
deletion process is started. The red LED
lights up during the deletion.
➭
Key CLR ALL > Menu DELETE MEMORY ?
Pressing key „S“ (6) deletes the entire device
memory. As a preventive measure against
accidental deletion you have to keep key „S“
(6) pressed for about 1 to 2 seconds before
the deletion process is started. The red LED
lights up during the deletion.
6.3.3 Exiting the Memory Menu
Set the rotary switch to position Geräteselb-
sttest/Speichermenü (Self-test/Memory
Menu) and press key „S“ (6) to exit the mem-
ory menu.
In operating mode „Memory mode“ the last
measured value indicated after a measure-
ment is shown when pressing key „S“ (6).
The storage operation - as well as transmis-
ion of the values via USB port - is indicated
by a flickering of the LEDs. If more than 10
values are stored for one DUT, the red LED
lights up additionally for approx. half a sec-
ond, thus signalling that it was not possible
to store the measured values.
6.3.4 Reading out Stored Measured Values
at the PC
Prerequisite: The test instrument may not be
set to Geräteselbsttest/Speichermenü
(Memory Menu or Self-test).
The stored measured values can be trans-
mitted from the test instrument to a PC via
the analysis software and the USB port
where they can be evaluated and docu-
mented.
6.3.5 Barcode Scanner Function
Connect the barcode scanner to jack 23.
Only barcode scanners by GMC-I Mess-
technik GmbH may be used, e. g. type
B3261.
Barcode scanners with USB port are not
suitable.
In function „NUM+“ and „NUM-“ a text com-
prising a maximum of 24 characters which
has been scanned with the barcode scanner
is recorded as a description of the DUT. The
text is shown in the second line of the LCD
and stored.
6.3.6 Switching Off Safely
You have to exit the memory menu before
switching off the test instrument or discon-
necting it from the mains. Set the rotary
switch (4) to position Geräteselbsttest/Spei-
chermenü (Self-test/Memory Menu) and
press key „S“ (6) for approx. half a second.