User manual

60 GMC-I Messtechnik GmbH

❑

Set measurement duration of individual test steps (as of firmware 1.5.0)

Testing time for the respective measurement can be influenced

with these parameters. If a test step for a single measurement is

involved, the entire test step has a duration of the time entered in

seconds. If a test step for a multiple measurement is involved, the

measurement duration for each measuring point is influenced.

If 0 seconds is selected, continuous measurement is conducted

which can only be ended by pressing a key.

For measuring sequence VDE 0701-0702-PRCD with the following set-

ting „PRCD type: PRCD (SPE)“ the measurement duration cannot be in-

fluenced.

The measurement duration which has been set in this case only affects

the RPE measurement with PRCD types „PRCD (standard)“ and

„PRCD-S (SPE)“.

Parameter

(as of FW 1.5.0)

Meaning

RPE measurement

duration

Set testing time for the protective conductor resistance

measurement (0 to 60 seconds)

IPE measurement

duration

Set testing time for the protective conductor current

measurement (0 to 60 seconds)

IG measurement

duration

Set testing time for the device leakage current measure-

ment (0 to 60 seconds)

Parameter

(as of FW1.8.0)

Meaning

IB measurement

duration

Set testing time for the touch current measurement

(0 to 60 seconds)

IB SK II measurement

duration

(only for IEC 60974) Set testing time for the touch current

measurement at PC II parts (with the exception of welding

outputs) (0 to 60 seconds)

RISO SK II measurement

duration

Set testing time for RISO measurements at PC II parts

(0 to 60 seconds)