User manual

GMC-I Messtechnik GmbH 9

3 Getting Started

3.1 Installing the SI Module

➭ SECUTEST... only: Remove the cover from the lid of the SECUTEST.... For

this purpose, press the cover to the side.

➭ Insert the SI module into the lid and fasten it with the two knurled re-

taining screws.

➭ Connect the module to the connection socket of the RS232 interface

of the test instrument via the ribbon cable.

➭ SECUTEST... only: Below the SI module there is a compartment provided

in the lid for the storage of the probe lead. Lock the flap inserted in the

module on the hinge of the lid so that the probe lead will not fall out

when the lid is closed.

3.2 Activating the SI Module

To activate the SI module, a connection to the RS232 interface of the

SECUTEST... must be established and the test instrument must be con-

nected to the mains.

Attention!

As long as the signal lamp lights up at the SI module, a syn-

chronization between the test instrument and the SI module is

being performed during which no test data may be imported

from the SI module. Do not press any key at the test instru-

ment.

Initial Start-up – Clear memory

For initial start-up, the memory should be completely cleared by means

of a reset:

➭ Activate the menu function by pressing .

➭ Select the Setup menu and then the menu Clear memory.

➭ Press + simultaneously.

➭ Reset date and time after initialization.