User manual

6 GMC-I Messtechnik GmbH
1 Applications
The SI (Storage Interface) module SECUTEST SI+ is a special accessory
for the the following test instruments:
SECUTEST..., SECULIFE ST, PROFITEST 204 and METRISO 5000 D-PI.
It is installed in the lid of the tester and fastened with two knurled screws.
The test results determined with the test instrument are directly trans-
ferred to the SI module via the ribbon line.
1.1 Application SECUTEST...
All measured values for approximately 300 reports (amount of one work-
ing day) can be stored in this memory.
Via a serial RS232 port or an USB interface, the stored measured values
can be transferred from the SECUTEST SI+ to the PC, archived and pro-
cessed there with our software packages (e.g. for the preparation of
invoices), or printed directly into a pre-made form.
Note
Transmission of the data from the memory of the SI module to the
PC via the RS232 or USB interface is only possible when the SI
module is connected to the test instrument.
Note
Data transmission from the memory of the SI module to the PC
via USB interface is only possible if you have installed the
required device driver to your PC via the Driver Control soft-
ware.