User manual

14 GMC-I Messtechnik GmbH
If there are no data available in the test instru-
ment when the menu item Protocol is called up,
the following message appears:
5.2 Automatic Report Storage
All test results are automatically allocated a consecutive ident number*
provided the Autostore function is active. After the safety test as well as
after the function test, a note is displayed indicating that the test data are
being stored.
When the SI module is deactivated, proceed as follows to activate the
Autostore function in the test instrument:
➭ SECUTEST... test instrument:
Select the desired test at the function selector switch of the test instru-
ment.
➭ older versions SECUTEST 0701/0702S:
Set the function selector switch of the test instrument to the MENUE
position.
➭ Move the cursor to Setup and confirm with .
➭ Move the cursor to Configureand confirm with .
➭ Move the cursor to Autostore : activate or deactivate the function with .
* It consists of max. 24 digits. Counting starts with the first four digits in
each case, beginning with 0000.