Manual

Gossen Metrawatt GmbH 87
Measurement can be
aborted by pressing the ON/START ▼ or ESC key.
The following measured values are displayed:
– R L - PE : Active test resistance with upper and lower limit values
– t
a
: Response time (during which momentary resistance is
applied until the measurement is ended)
– R
min
- R
max
: Status display indicating momentary resistance
with reference to the number of possible resistances
– U
L1PE
: Momentary voltage at the test probes between phase
conductor L1 and protective conductor PE
– U
L2PE
: Momentary voltage at the test probes between phase
conductor L2 and protective conductor PE
– U
L1L2
: Momentary voltage at the test probes between phase
conductors L1 and L2
– I
LPE
: Test current flowing through the active resistance
– f: Frequency of the applied voltage
Evaluation
In order to evaluate the measurement, it must be stopped. This
applies to manual as well as automatic measurement. Press the
ON/START ▼ or ESC key to this end. The stopwatch is stopped and
the evaluation window appears.
Retrieving Saved Measured Values
The measured value cannot be saved to memory and included in
the test report until it has been evaluated (see also section 9.4).
With the help of the key
shown at the right
(MW: measured value / PA: parameter), the setting
parameters can be displayed for this measurement.
OK
NOT OK