Manual

Gossen Metrawatt GmbH 39
10.8 Freely Selectable Parameter Settings or Limit Values
10.8.1 Changing Existing Parameters
Individual parameters can be changed for certain measuring func-
tions, i.e. adjusted within predetermined limits.
The EDIT menu doesn’t appear until after switching to the
right-hand column and selecting the editable parameter .
Example for RLO Measuring Function – Parameter: LIMIT RLO
1 Open the submenu for setting the desired parameter (no fig-
ure, see section 10.7).
2 Select the editable parameter – identified with the icon –
with the or  scroll key.
3 Select the edit menu by pressing the key.
4 Select the respective characters with the left or right cursor
key. The character is accepted by pressing the  key. The
value is acknowledged by selecting
✓ and then pressing the
 key.
Note
Observe the predefined limits for the new setting value.
Enter any places to the right of the decimal point as well.
10.8.2 Adding New Parameters
For certain measuring functions, additional values within pre-
defined limits can be added in addition to the fixed values.
The EDIT+ menu doesn’t appear until after switching to the
right-hand column.
Example for I
N
Measuring Function – Parameter: I
N
1 Open the submenu for setting the desired parameter
(no figure, see section 10.7).
Select the edit menu by pressing the key.
2 Select the respective characters with the LEFT or RIGHT cursor
key. The character is accepted by pressing the  key. The
value is acknowledged by selecting
✓ and then pressing the
 key. The new parameter is added to the list.
Note
Observe the predefined limits for the new setting value.
Enter any places to the right of the decimal point as well.
Select the EDIT menu.
Select value/U/M.
Select value/U/M.
Accept value/U/M.
Delete character
✓ Save value (to list)
Select the
EDIT+ menu.
Select value/U/M.
Select value/U/M.
Accept value/U/M.
Delete character
✓ Save value (to list)