Manual

34 Gossen Metrawatt GmbH
9.3.2 Searching for Structure Elements
Regardless of the currently selected object, the search is started
at database.
Go to page 3/3 in the database menu.
After selecting text search...
... and entering the desired text (only full matches are found – no
wild cards, case sensitive) ...
... the first match is displayed.
Further matches can be found by selecting
the icon shown at the right.
If no further matches are found, the message shown above is dis-
played.
9.4 Saving Data and Generating Reports
Preparing and Executing a Measurement
Measurements can be performed and stored to memory for each
structure element. Proceed as follows, adhering to the prescribed
sequence:
➭ Select the desired measurement with the rotary knob.
➭ Start the measurement by pressing the ON/START ▼ or I
N
key.
Upon completion of measurement, the  Floppy Disk softkey is
displayed.
➭ Briefly press the Save Value key.
The display is switched to the memory menu or the
structure view.
➭ Navigate to the desired memory location, i.e. to the desired
structure element / object, for which the measurement data
will be saved.
➭ If you would like to save a comment along with the
measurement, press the key shown at the right and
enter a designation via the “EDIT” menu as described in
section 9.3.1.
➭ Complete data storage by pressing the “STORE” key.
Saving Error Messages (pop-ups)
If a measurement is ended without a measured value due to an
error, the measurement can be saved along with the pop-up by
pressing the “Save Value” key. The corresponding text is read out
in ETC instead of the pop-up symbol. This only applies to a limited
number of pop-ups (see below). Neither a symbol nor a text can
be accessed in the test instrument’s database itself.
Alternative Storage Procedure
➭ The measured value can be saved to the last se-
lected object in the structure diagram by pressing
and holding the Save Value key, without switching the
display to the memory menu.
Scroll up
Scroll down
Comfirm selection /
Display object
Menu selection page 3/3
change level
or ID number
Search for ID number
Search for text
Search for ID number or text.
Select character
Select character
Accept character
Delete character
Character selection:
✓ Save object designation
Continue searching
End search