Manual

Gossen Metrawatt GmbH 33
9.3.1 Creating Structures (example for electrical circuit)
After selection with the MEM key, all setting options for the cre-
ation of a tree structure are made available on three menu pages
(1/3, 2/3 and 3/3). The tree structure consists of structure ele-
ments, referred to below as objects.
Selecting the Position at which a New Object will be Added
Use the  keys in order to select structure elements.
Change to the sub-level with the  key.
Go to the next page with the >> key
Creating a New Object
Press the key in order to create a new object.
Select a new object from a list.
Select the desired object from the list with the keys and
acknowledge with the  key.
Depending upon the profile selected in the test instrument’s
SETUP menu (see section 8), the number of object types may be
limited, and the hierarchy may be laid out differently.
Entering a Designation
Enter a designation and then acknowledge it with ✓.
Note
Acknowledge your entry with ✓and , because the entry
will otherwise not be accepted.
Entering a Comment
Enter a comment and then acknowledge it with ✓.
Note
Acknowledge your entry with ✓ and , because the entry
will otherwise not be accepted.
Setting Electrical Circuit Parameters
For example, nominal current values must be entered here for the
selected electrical circuit. Measuring parameters which have been
accepted and saved in this way are subsequently accepted by
the current measuring menu automatically when the display is
switched from the structure view to measurement.
Note
Electrical circuit parameters changed during structure
creation are also retained for individual measurements
(measurement without saving data).
If you change the electrical circuit parameters specified by the
structure in the test instrument, a warning is displayed when
the change is saved (see error message on page 25).
Scroll up
Scroll down
Comfirm selection /
Display object
Nextpage
change level
or ID number
Create object
Delete object
VA: Show measurement data
Edit designation
Scroll up
Scroll down
Comfirm selection
Select character
Select character
Accept character
Delete character
Character selection:
✓Save object designation
A, a, 0, @
Select parameter
Parameter settings list
Acknowledge parameter selection
Acknowledge parameter setting
and return to page 1/3
Select parameter setting
in the database menu.